| Manufaturer: | KUKEN |
| Model: | KG-25 |
✔ Note: Displayed prices are standard prices.
⚡ Please click Request a quote to unlock Competitive pricing and delivery dates within 24 hours.
✅ Guaranteed 100% Genuine (CO/CQ) – Free quote.
✈️ We deliver to your doorstep under DAP terms. Customs clearance is for your account.
✉️ Can't find the product you need? Please send the picture/specifications/model/product code to [email protected]. We will find it for you.
⭐ Review us here: Review Now ★ Trustpilot
The KG-25 is a pneumatic straight grinder designed for deburring, chamfering, and surface finishing of metal parts.
The grinder uses a 6 mm (1/4") collet to secure grinding stones or burr bits.
The no-load rotational speed is 3 400 rpm, providing efficient material removal.
The tool measures 203 mm in length and weighs approximately 0.75 kg, enabling comfortable one-handed operation.
A nominal supply pressure of 0.6 MPa (6 bar or 90 psi) is recommended for optimal performance.
Air consumption is around 0.45 m³/min, so ensure your compressor can sustain that flow for continuous use.
The inlet thread is Rc 1/4", and a hose with at least a 6 mm inner diameter is advised to minimize pressure drop.
Exhaust is directed rearward, pulling air away from the workpiece and operator.
The KG-25 does not feature an onboard speed control. Speed will vary slightly based on supply pressure and load.
Use 88 mm × 6 mm stones or burr attachments compatible with a 6 mm shank.
One 88 mm × 15 t eraser wheel
One 14 mm open-end wrench
One Rc 1/4" coupling plug
One inline air regulator
Yes. Just ensure the shank or hole diameter matches the 6 mm collet specification.
Add a few drops of pneumatic tool oil into the air inlet before every work shift, or after 8–12 hours of cumulative use.
Disassemble your inline air preparation unit, rinse the filter elements with clean solvent, let dry, and reassemble.
Collet and nut (inspect for wear every 50 hours)
Air filter element (replace every 200 hours)
O-rings and seals (replace when leakage or air loss is detected)
Genuine spare parts are available from KUKEN distributors as QTE Technologies. Provide part numbers or a service manual reference when ordering.
Safety glasses or face shield
Dust mask or respirator for fine particles
Cut-resistant gloves
Hearing protection if noise levels exceed 85 dB
Shut off and bleed air supply.
Use the provided wrench to loosen the collet nut.
Center the grinding stone shank in the collet.
Tighten the nut firmly—but do not over-torque.
Always maintain firm, two-handed control.
Do not apply excessive lateral force to the stone.
Keep the workpiece firmly clamped or secured.
The KG-25 carries a 6-month limited warranty against manufacturing defects when used per guidelines.
Contact your local KUKEN distributor as QTE Technologies (qtetech.com/en)
KUKEN products are available worldwide through distributors as QTE Technologies. Check availability and shipping options with your regional supplier.
Reach out to KUKEN customer service at the telephone or email provided in the product manual for troubleshooting and service requests / or contact QTE Technologies (qtetech.com/en).